Setting Up Yeastar TA Analogue Adaptors

Step 1: add the adaptor in the portal

1. Go to Voice → Phones and click Add a new phone.
2. Choose Yeastar and your model as the Phone Type.
3. Enter the MAC address from the label on the back of the unit.
4. Enter a description, an admin password for the adaptor, and whether you want call waiting.
5. Choose the number for each phone port and save.
6. Copy the AES Key shown on the page. You need it in step 4.

Step 2: reset and connect the adaptor

If the adaptor has been used before, log in and choose System → Reset and Reboot → Reset to Factory Defaults. Connect it to your network and power, and plug a phone into the phone port.

Step 3: find the adaptor's address

Pick up the phone and dial ***1. The adaptor reads out its IP address. Enter that address in a browser on the same network and log in as admin (default password password).

Step 4: enter the provisioning settings

Open the System page and scroll to Auto Provision Settings:

Click Save, then Apply Settings, then restart the adaptor. It downloads its settings, updates its firmware if needed, and your numbers register. Make a test call each way.